Description
Key Specifications
| Parameter | Value | Parameter | Value |
|---|---|---|---|
| Part Number | EP-GEG120ES | Series / reference | Heavy-Duty Radial |
| Bore d (mm) | 120 | Outside diameter D (mm) | 210 |
| Width B (mm) | 115 | Inner-ring width C (mm) | 70 |
| Dk (mm) | 180 | R1s / R2s min | 1.0 / 1.0 mm |
| Articulation α | 16° | Dynamic load Cr | 1080 kN |
| Static load C0r | 5400 kN | Weight | 1500 g |
| Lubrication | Relubrication required | Sealing | Open / unsealed |
| Sliding pair | Steel / steel | Surface / liner | Outer and inner rings phosphate treated |
Product Description
EP-GEG120ES construction and application notes
EP-GEG120ES is the 120 mm-bore model in the GEG..E / GEG..ES Heavy-Duty family. Its nominal envelope is d 120 mm × D 210 mm with B 115 mm overall width.
Heavy-duty GEG radial construction with a single axial split. Type ES uses lubricating grooves and holes in both rings. The 16° articulation value shown in the model table helps define angular movement around the spherical sliding surface. This construction is intended for slow oscillating or pivoting joints where a planned lubrication path is available. On EP-GEG120ES, that construction is paired with a 120 mm bore, 210 mm outside diameter, 115 mm overall width, 1080 kN dynamic rating and 16° catalogue articulation value.
For EP-GEG120ES, the GEG heavy-duty family uses a wider radial section than the comparable GE range. Housing width and shoulder support therefore deserve extra attention when a machine needs the heavier GEG envelope but remains on a greaseable steel-on-steel system.
Installation and fit
For EP-GEG120ES, start the fit review from its 120 mm bore and 210 mm outside diameter, then check how the 115 mm bearing width is supported by the housing shoulders. The fitting-tolerance resource includes H7 and h6 among the reference classes; final fit still depends on ring loading, housing stiffness, temperature and the machine interface.
Selection Context
How to verify EP-GEG120ES in the joint
For EP-GEG120ES, before treating this model as a repeat order, compare the installed joint with the current dimensional row. Check the shoulder geometry around the listed width and outside diameter, especially when the old bearing or housing shows wear. Replacement planning should include the condition of the pin and housing, since wear outside the bearing can change the apparent fit. Include quantity and application with the dimensional data so the response can distinguish a one-off replacement from a repeat requirement.
Cross-Reference
Brand reference for EP-GEG120ES
Cross-reference designations help identify the family. They do not replace dimensional, suffix, sealing and application checks.
| Brand | Reference designation | Verification note |
|---|---|---|
| SKF | GEH120ES | Reference designation; verify dimensions and suffix. |
| FAG | GEH120ES | Reference designation; verify dimensions and suffix. |
| ELGES | GE120FO | Reference designation; verify dimensions and suffix. |
| IKO | GE120GS | Reference designation; verify dimensions and suffix. |
Technical Documents
Drawings and order documents
Related Products
Compare the same bore across other constructions
RFQ
Request a quote for EP-GEG120ES
For EP-GEG120ES, include quantity, application, operating environment and any drawing or document requirement. The enquiry area keeps this 120 × 210 × 115 mm model in context so the quotation can be tied to the exact product rather than only the family name.
Model: EP-GEG120ES
