Beschrijving
Key Specifications
| Parameter | Value | Parameter | Value |
|---|---|---|---|
| Part Number | EP-PB28 | Series / reference | Bronze-Lined |
| Bore d (mm) | 28 | Outside diameter D (mm) | 62 |
| Width B (mm) | 35 | Inner-ring width C (mm) | 25 |
| d1 min (mm) | 32.3 | R1s / R2s min | 0.6 / 0.6 mm |
| Articulation α | 15° | Dynamic load Cr | 59 kN |
| Static load C0r | 138 kN | Weight | 530 g |
| Lubrication | Relubrication required | Sealing | Open reference construction |
| Sliding pair | Steel / bronze | Surface / liner | Bronze liner in the outer race |
Product Description
EP-PB28 construction and application notes
EP-PB28 is the 28 mm-bore model in the PB Bronze-Lined family. Its nominal envelope is d 28 mm × D 62 mm with B 35 mm overall width.
Outer race lined with a bronze liner, with a lubricating groove and hole in the outer ring. The steel/bronze sliding pair is intended for lubricated pivoting service, with inspection of wear, lubrication path and adjacent pin condition remaining part of maintenance. On EP-PB28, that construction is paired with a 28 mm bore, 62 mm outside diameter, 35 mm overall width, 59 kN dynamic rating and 15° catalogue articulation value.
For EP-PB28, the PB family uses a bronze-lined sliding interface and a lubricated pivoting service strategy. Its construction should be compared with PTFE-lined and steel-on-steel alternatives by considering lubrication access, motion pattern and the available joint envelope.
Installation and fit
For EP-PB28, start the fit review from its 28 mm bore and 62 mm outside diameter, then check how the 35 mm bearing width is supported by the housing shoulders. The fitting-tolerance resource includes H7 and h6 among the reference classes; final fit still depends on ring loading, housing stiffness, temperature and the machine interface.
Selection Context
How to verify EP-PB28 in the joint
For EP-PB28, for a replacement check, begin with the joint envelope and then compare the full bearing marking. Compare the complete envelope with the removed part; a matching bore by itself does not establish the correct housing fit. Also confirm whether the machine has a dependable lubrication route and whether contamination can reach either bearing face. Where the pin is worn, provide the least-damaged measurement and note whether a new pin will be installed with the bearing.
Cross-Reference
Brand reference for EP-PB28
Cross-reference designations help identify the family. They do not replace dimensional, suffix, sealing and application checks.
| Brand | Reference designation | Verification note |
|---|---|---|
| IKO | PB28 | Reference designation; verify dimensions and suffix. |
Technical Documents
Drawings and order documents
Related Products
Compare the same bore across other constructions
RFQ
Request a quote for EP-PB28
For EP-PB28, include quantity, application, operating environment and any drawing or document requirement. The enquiry area keeps this 28 × 62 × 35 mm model in context so the quotation can be tied to the exact product rather than only the family name.
Model: EP-PB28
